Description
These ooey-gooey marshmallow wands found at the Candy Palace at the Disneyland Resort are more than meets the eye! Sweet, buttery caramel covers a marshmallow wand while the whole treat get covered in strawberry flavored pink white chocolate and topped with purple sanding sugar stripes… just like the Cheshire Cat’s tail. A Disneyland-inspired treat.
Ingredients
Scale
- 24 marshmallows
- 1 eleven ounce package of individually wrapped caramels (like Kraft)
- 2 tablespoons water
- 11 ounces of pink candy melts
- 1 tablespoon of coconut oil
- 1/4 teaspoon of strawberry flavor oil (like Lorann – must be oil based not water based! See notes below)
- 6 ounces of white candy melts
- 1 cup purple sanding sugar
- 6 lollipop sticks
Instructions
- Place four marshmallows, round side facing out, on each lollipop stick. Set aside.
- Place a sheet of parchment on a sheet pan. Butter it lightly and set aside.
- Unwrap all the caramels and add to a small saucepan. Pour water in and heat over medium-low heat.
- Stir constantly until everything has melted and caramels are smooth (about 7-8 minutes).
- Once melted (caramels should drip in a ribbon from a spoon back into the pan), dip each wand into the caramel, turning quickly to coat. Let excess caramel drip off for at least 30 seconds, turning while it drips for even coating, and then place on the buttered parchment.
- When all the wands have been dipped, refrigerate for thirty minutes.
- About 15 minutes to wands coming out of refrigerator, set up your sanding sugar station by setting out an empty wide, shallow bowl and another bowl with sanding sugar in it.
- Remove wands from the refrigerator. Then, in a double boiler, combine pink candy melts, strawberry flavoring, and coconut oil (this can alternatively be melted in the microwave as well. Please see notes below.). Melt over medium heat, stirring constantly until smooth. Do not let the temperature go above 110°f (you might want to use a candy thermometer if you’re unsure).
- Once smooth, dip caramel covered marshmallow wands in the chocolate, turning evenly to coat and fill in any gaps. Let the pink chocolate drip back into pan and lightly scrape one side on the edge of pan to remove any additional excess. Place back on buttered parchment. Repeat for all wands and let coating dry about 30 minutes.
- Next, melt the white chocolate (you can melt in a heavy duty piping bag as well), and create stripes on the first marshmallow wand, and immediately pour the purple sanding sugar over the stripes, letting excess catch in the empty bowl. You can press the wand lightly into sugar if you’d like a more thicker coating (I was fine with the lighter stripes). Set aside. Repeat with additional wands. If sanding sugar adheres to the pink coating, use a small brush to brush crystals away after fully dried. Then enjoy!
Notes
- Melted caramel is HOT! Use caution in the kitchen. Do not dip your fingers or hands into the caramel has it can adhere to skin and burn you. Keep away from children.
- Use hot water to remove caramel from pans and utensils.
- If you wish to microwave your candy melts, combine them with strawberry flavoring, and coconut oil in a microwave safe bowl, and heat for 30 seconds on half power, stir, and continue to microwave in about 15-20 second increments until smooth.
- If you have extra melted caramel that has dried around your wand, use kitchen shears to remove it immediately after removing from the refrigerator.
- Did your chocolate coating break when you first dipped your wand in? Wait for the chocolate to cool down more. It should drip freely from a spoon without it seizing when the spoon is shaken slightly (will cause crevices in the chocolate on the spoon). If it breaks on the wand, your wand also might be too cool, so let them warm up more. And don’t worry, once that chocolate starts to firm up, you can dip it AGAIN into the chocolate to get a more even, although slightly thicker, coating.
Keywords: treat, marshmallow, Candy Palace, strawberry, caramel, white chocolate